Cleaning, Care And Maintenance; Troubleshooting; Installation; Safety - Stiebel Eltron SBB 600 WP SOL Utilisation Et Installation

OPERATION | INSTALLATION

CLEANING, CARE AND MAINTENANCE

4. Cleaning, care and maintenance
f Have a contractor regularly check the appliance, the safety f
assembly and all fitted accessories.
f Never use abrasive or corrosive cleaning agents. A damp f
cloth is sufficient for cleaning all plastic parts.
Signal anode consumption indicator
Material losses
!
If the consumption indicator changes colour from white to
red, have the signal anode checked by a heating contrac-
tor and if necessary replaced.
Signal anode consumption indicator
1 white = anode OK
2 red = check by heating contractor required
Scaling
f Almost every type of water deposits limescale at high tem- f
peratures. This settles inside the appliance and affects both
the performance and service life. The indirect coils and fitted
accessories should therefore be descaled from time to time.
A heating contractor who knows the local water quality will
tell you when the next service is due.
f Check the taps/valves regularly. You can remove limescale f
deposits at the tap outlets using commercially available des-
caling agents.
5.

Troubleshooting

Telephone your contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000):
16 | SBB 600-1000 WP SOL
1 2
000000-0000-000000
Made in Germany

INSTALLATION

6.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1

General safety instructions

We can only guarantee trouble-free function and operational reli-
ability if original spare parts intended for the appliance are used.
6.2

Regulations, standards and instructions

Note
Observe all applicable national and regional regulations
and instructions.
7.

Appliance description

7.1

Standard delivery

Delivered with the appliance:
- Signal anode
- Heat conducting paste
- Thermometer
- Additional type plate
- Label "Signal anode information"
7.2

Accessories

7.2.1 Required accessories

Depending on the static pressure, safety assemblies and pressure
reducing valves are available. These type-tested safety assemblies
protect the appliance against inadmissible excess pressure.

7.2.2 Further accessories

In addition, flanged as well as threaded immersion heaters and
thermal insulation are available as accessories.
If it is not possible to insert a rod anode from above, install a
segmented anode.
WWW.STIEBEL-ELTRON.COM