Table des Matières
Publicité
Installer le panneau de porte
Soulever le panneau de la porte et installer le montant de charnière extensible sur
le montant de mur.
Ajuster le montant extensible du côté fermeture sur le côté opposé du montant du
mur.
Instale el panel de la puerta
Levante el panel de la puerta e instale la jamba de expansión de bisagra sobre la
jamba mural.
Instale la jamba de expansión del lado de contacto en la jamba mural opuesta.
9.
Secure the Door Panel
Hinge Expander Jamb
Montant à charnière extensible
Jamba de espansión de bisagra
Inside Groove/Rainure intérieure/Ranura interior
#8-18 x 1/2" Self-Drilling Panhead Screw
Vis à tête ronde autoforeuse #8-18 x 1/2"
Tornillo autoperforante de cabeza redonda del #8-18 x 1/2"
3/16"
(5 mm)
Strike Expander Jamb
Butée extensible
Jamba de expansión de contacto
Outside Groove/Rainure extérieure/Ranura exterior
Adjust the door panel until both the hinge expander jamb and strike expander
jamb are equally spaced.
Open and close the door panel. Make sure the bottom seal does not hang on the
bottom track. Adjust if needed until the bottom seal is properly positioned.
NOTE: If the hinge expander jamb is adjusted less than 3/8" (1 cm) from the wall,
use the screw groove farthest from the wall. If the hinge expander jamb is adjusted
3/8" (1 cm) to 3/4" (1.9 cm), use the screw groove closest to the wall. Do not adjust
beyond 3/4" (1.9 cm).
While holding the door panel in place, insert three #8-18 x 1/2" self-drilling
screws into the starting groove in the hinge expander jamb and tighten.
Sterling
Hinge Expander Jamb
Montant à charnière extensible
Screw Starting Groove
Jamba de espansión de bisagra
Vis de la rainure
Ranura para comenzar a atornillar
3/16"
Strike Expander Jamb
(5 mm)
Butée extensible
Jamba de expansión de contacto
Screw Starting Groove
Vis de la rainure
Ranura para comenzar a atornillar
15
1063212-2-B
Publicité
Table des Matières
