Possible Cause(S); Troubleshooting Guide - Blodgett MT3255G Manuel D'installation

POSSIBLE CAUSE(S)

SYMPTOM: Blower motors not running
Blower control switch in OFF position
S
No power to oven
S
Motor fuses blown
S
Control circuit fuse blown (right fuse on control
S
panel door)
Motor(s) burned out
S
SYMPTOM: Manual control displays: EEE
Control not properly installed
S
Internal problem with control
S
Loose thermocouple connections at control
S
Short in thermocouple
S
SYMPTOM: Conveyor belt will not run
Conveyor control switch in OFF position
S
Control circuit fuse blown
S
Belt hooked on something in oven
S
Defective conveyor drive motor
S
Defective conveyor drive motor controller
S
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that
All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot as-
sume responsibility for damage as a result of servicing done by unqualified personnel.
WARNING!!
Always disconnect the power supply before cleaning or servicing the oven.
Maintenance
SUGGESTED REMEDY
Turn to ON position
S
Replace main fuses or reset breakers
S
Replace fuses
S
Replace fuse
S
*
S
Reinstall
S
*
S
*
S
*
S
Turn to ON position
S
Replace fuse
S
Turn oven OFF. Unhook and resolve problem
S
*
S
*
S
23

Troubleshooting Guide