Oven Adjustments For Cooking - Blodgett MT3255G Manuel D'installation

Operation

Oven Adjustments for Cooking

The combination of belt time, oven temperature,
and air flow are important for achieving quality re-
sults from your Blodgett conveyor oven. Use the
following guidelines to adjust the belt time and
oven temperature of your unit. For questions re-
garding further oven adjustments, please contact
your local Blodgett Sales Representative for assis-
tance.
CONVEYOR SPEED AND OVEN TEMPERATURE
Conveyor belt speed (cook time) and oven tem-
perature are the two variables used when fine tun-
ing your oven for a specific product. To determine
the optimum bake time and temperature, make
small changes for each trial and keep one variable
constant. For example, if the oven temperature is
460_F (238_C) and the belt speed is 7 minutes,
but the pizza is not browned enough, increase the
temperature to 475_F (246_C) and keep the belt
speed the same. However, if the center of the pizza
is not completely cooked, keep the oven tempera-
ture the same, and increase the bake time to 7
minutes and 30 seconds. In general, raise the
bake temperature to increase browning, and
lengthen the belt time to increase doneness.
FINISHED PRODUCT TEMPERATURES
Internal temperatures of the cooked products
should be measured immediately after the prod-
uct exits the cooking chamber to ensure a safe
food temperature. Internal pizza temperatures
should be over 165_F (74_C). Minimum tempera-
ture guidelines vary depending on the food items.
AIR FLOW ADJUSTMENTS
Slide the product clearance adjustment plates to
the lowest possible setting for your menu items.
Lowering the clearance plates will reduce the
amount of hot air escaping from the chamber
openings.
Most often, the ideal oven settings can be dialed
in without making any changes to the airplate. The
oven configuration should not be modified unless
the oven time and temperature adjustments have
proven unsuccessful.
Air flow adjustments may be necessary to fine
tune the oven for your particular product. The air
plate, located at the top of the baking chamber,
contains holes that can be covered using Block-off
Plates. The plates can easily be adjusted to regu-
late the air flow for your particular needs. Use the
following guidelines to adjust the Block-off Plates.
1. Ensure the oven is Off and completely cooled.
2. Remove both upper end plugs. Loosen the
wing nuts on the bottom of each end plug.
3. Loosen the wing screws holding the air plate
retainers in place. Remove the four wing
screws from the control box end of the oven.
Slide the air plates straight out from both ends
of the oven.
4. Remove the wing nuts, screws, and washers
holding the Block-off Plates.
5. Adjust the plates.
6. Replace the wing nuts, screws, and washers
to tightly secure the Block-off plates in their
new locations. Make a sketch of the final air-
plate setup for future reference.
NOTE: One or two block-off plates may be left
off entirely if appropriate to obtain the
desired results.
7. Replace the air plate and upper end plugs.
18
Figure 22