Maintenance; Cleaning - Blodgett MT3255G Manuel D'installation

Maintenance

Cleaning

WARNING!!
Always disconnect the power supply be-
fore cleaning or servicing the oven.
WARNING!!
If the oven needs to be moved, the gas
must be turned off and disconnected from
the unit before removing the restraint. Re-
connect the restraint after the oven has
been returned to its original location.
Follow this recommended cleaning schedule for
proper oven performance.
Daily:
1. Clean the conveyor belt using a wire brush. Al-
low any foreign material to drop into the crumb
pans.
2. Empty and clean the crumb pans.
3. Make sure cooling fans are operating.
Every Three Months:
1. Brush and clean the guards of the cooling
fans.
Every Six Months:
1. Unplug the oven. Disconnect the gas connec-
tions.
2. Remove both crumb pans from the ends of the
conveyor.
3. Remove both upper end plugs. Loosen the
wing nuts on the bottom of each end plug.
Figure 24
4. Remove both lower end plugs.
5. Remove the conveyor belt as follows:
a.) Use needle-nose pliers to remove the
conveyor belt master links.
b.) Slide the belt out from one end. Be sure to
roll the belt as shown in Figure 25. Other-
wise the belt will be upside down when re-
threading.
6. Remove the non-drive side conveyor support.
7. Remove the drive side conveyor support as
follows:
a.) Remove the 1/4" hex bolt and nut (inside
control box), that fastens the drive side
conveyor support to the control box. See
Figure 26.
b.) Remove the drive chain from the sprocket
by pushing the conveyor assembly in to
loosen the chain. If unable to push assem-
bly, loosen motor mounts.
c.) Slide the conveyor support out of the
oven.
20
Figure 25