Nozzles; Conveyor Belt Support - Blodgett MT3255G Manuel D'installation

NOZZLES

1. Install nozzles from center of oven working to-
ward the ends. Make sure the bottom of
nozzle fits into slot in the nozzle support to-
ward the front of the oven.
2. Secure the nozzle hold-down strip across the
inside front of the oven using the existing
screws located on the oven wall.
Figure 5
Installation

CONVEYOR BELT SUPPORT

1. Slide the left conveyor support (with sprocket
on the end of the shaft) into the support tracks.
The sprocket must be inside the control box
after being pushed into the oven.
2. Install the drive chain around the drive motor
and the sprocket on the conveyor support.
Push the support back to tighten the chain.
3. Tighten the four bolts on the control box.
4. Slide the right conveyor support into the sup-
port tracks until it touches the left stop.
7
Oven Assembly
Figure 6
Figure 7