Use Procedure; Maintenance; Controller Startup; Starting The Pump - Agilent Technologies Turbo-V 3K-T Notice De Mode D'emploi

16 Instructions for Use

Use procedure

Use procedure

Controller Startup

To startup the controller plug the power cable into a suitable power
source and set the line switch to the position 1.

Starting the Pump

To start the pump press the START push-button on the controller
front panel.

Pump Shutdown

To shutdown the pump press the STOP push-button on the controller
front panel.

Maintenance

The Turbo-V 3K-T Rack Controller does not require any maintenance.
Any work performed on the controller must be carried out by
authorized personnel.
When a fault has occurred it is possible to use the Agilent repair
service. Replacement controllers are available on an advance
exchange basis through Agilent.
WARNING! Before carrying out any work on the controller, disconnect it from the supply.
If a pump is to be scrapped, it must be disposed off in accordance
with the specific national standards.
200/260 Turbo-V 3K-T Rack Controller User Manual / 87-900-988-01 (D)