Use Procedure; Maintenance; Controller Startup; Starting The Pump - Agilent Technologies TwisTorr 74FS AG Rack Mode D'emploi

Use Procedure

Controller Startup

To startup the controller plug the power cable into a suitable power
source.

Starting the Pump

To start the pump, confirm the interlock input (shorting pins 3÷8
on P1) and press the START pushbutton on the controller front panel.

Pump Shutdown

To shutdown the pump press the STOP push-button on the controller
front panel.

Maintenance

The TwisTorr 74 FS AG Rack series controller does not require any
maintenance. Any work performed on the controller must be carried
out by authorized personnel.
When a fault has occurred it is possible to use the Agilent repair
service. Replacement controllers are available on an advance
exchange basis through Agilent.
WARNING! Before carrying out any work on the controller, disconnect it from the supply.
If a controller needs to be scrapped, it must be disposed off in
accordance with the specific national standards.
TwisTorr 74FS AG Rack Controller User Manual / 87-901-055-01
Instructions for Use

Use Procedure

203/300
16