Table des Matières
Publicité
1
USE PROCEDURE
Interlock
The Interlock is a safety device designed by Varian to
protect the operator against serious injury caused by
the high voltage present on the pump power connector.
The controller is intended to be used with a HV cable
furnished with Interlock.
If the customer does not wish to use the HV cable with
interlock for particular application requirements, the
interlock cable of the controller (4) is available.
Start-up of the pump
To start the pump:
1. Connect the pump to the controller using the
specific HV cable.
2. Connect the Interlock of the HV cable to the plug
(5); if the HV cable is without the interlock cable,
connect the interlock cable of the controller (4) to
the plug (5).
3. Switch on the controller.
2
1. Input module for the controller power supply. It
3
2. High voltage output connector for the pump (KINGS
5
3. Input/output signal connector for fittings.
4. Controller cable Interlock
5. Plug Interlock
4
Controller Rear Panel
15/24
includes the protection fuse, the power supply plug,
and the EMC filter (not included into the plug/voltage
switch assembly).
or FISCHER type) power supply.
Controller Start-up
To start-up the controller, turn the main switch to ON,
after plugging the power cable into a suitable power
source.
Starting the Pump
The pump is activated only if the controller is powered
on and the pump itself is connected to the output
connector.
For
further
"Technical Information" section.
Pump Shutdown
To shutdown the pump, turn the main switch placed on
the front panel to OFF.
INSTRUCTIONS FOR USE
information
refer
to
87-900-053-01 (F)
the
Publicité
Table des Matières
