Initial Use; Switching On And Off; Checking The Automatic Oil System; Adjusting The Telescopic Handle - Parkside PAHE 20-Li A1 Traduction Des Instructions D'origine

Initial use

NOTE
► Comply with regulations regarding noise
protection and local rules. Using the appli-
ance on certain days (e.g. on Sundays and
public holidays), during certain times (midday
period, night time) or in certain locations
(e.g. health resorts, clinics, etc.) may be
restricted or prohibited.
Switching on and off
Switching on
♦ Press the safety lock-out
and then press the on/off switch
♦ After the starting process, the safety lock-out
can be released.
Switching off
♦ Release the ON/OFF switch

Checking the automatic oil system

Before starting work, check the window for the oil
level and the automatic oil system.
♦ Switch the appliance on and hold it over a
lightly coloured floor surface. The appliance
must not touch the ground.
♦ If there is an oil trace, the appliance is opera-
ting correctly.
♦ If there is no oil trace, clean the oil dispenser
or have the appliance repaired by our Customer
Service.
♦ To clean, wipe the residues from the oil
dispenser using a brush or cloth.
│ GB │ IE
■ 32
and keep it pressed
.
.

Adjusting the telescopic handle

The telescopic handle
ously by means of the quick release
♦ Activate the quick release
the length by pushing or pulling as required.
♦ Close the quick release
the desired working length of the telescopic
handle .
♦ If the screw of the quick release
ened, tighten it again with a hex key.

Adjusting the cutting angle

NOTE
► The cutting angle can be adjusted in 3 stages.
♦ Remove the battery pack
♦ Press the release button
♦ Adjust the angle of the motor unit to the required
position.
♦ Let go of the release button
unit will click into place.
♦ Insert the battery pack
ance.

Sawing techniques

WARNING!
► Pay attention to falling clippings.
► Be aware of the danger of branches flying
back.
NOTE
► Place the stop
you work more safely and quietly.
► Now you can begin with the sawing.
can be adjusted continu-
.
and adjust
again, thereby fixing
has loos-
from the appliance.
.
and the motor
back into the appli-
on the branch. This will help
PAHE 20-Li A1