Hama TS34A Mode D'emploi page 7

Warning
• Buy special or suitable installation material from a specialised dealer
for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage the product.
• Before installation, ensure that the chosen wall is suitable for the
weight to be installation, and make sure that there are no electrical
wires, water, gas or other lines in the wall at the installation site.
• Do not mount the product above locations where persons might linger.
• You can position the measuring station on a level outdoor surface using
the base.
• We recommend installing the measuring station securely on an outdoor
wall.
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang the measuring station using the opening intended for this purpose
(4).
6. Operation
6.1. Connection to the measuring station
• To connect the base station and the measuring station, place the two
devices as close together as possible.
• After you insert the batteries, the base station automatically searches for
a connection to the measuring station and performs initial setup. If the
device does not connect automatically, the manual search program on the
base station must be started.
Note
• Initial setup takes approximately 3 minutes.
• During the connection attempt, the radio symbol and the LED indicator
(1) on the measuring station will flash.
• Do not press any buttons during setup. Otherwise, values may not be
transmitted correctly and there is a risk of value errors and inaccuracies.
6