Authorized Use; Predictable Misuse; Basic Safety Instructions - Burkert 6212 Manuel D'utilisation

3.

auThOrized use

Non-authorized use of the solenoid valve Type 6212
may be a hazard to people, nearby equipment and
the environment.
• The device is designed to control, shut off and meter
neutral media up to a viscosity of 21 mm
• Provided the cable plug is connected and installed
correctly, e.g. Bürkert Type 2506, the device satisfies
protection class IP65 in accordance with
DIN EN 60529 / IEC 60529.
• During use observe the authorized data, the operat-
ing conditions and conditions of use specified in the
contract documents, on the rating plate and in the
operating instructions, as described in the chapter
entitled 6.Technical Data.
• Correct transportation, correct storage and installation
and careful use and maintenance are essential for reli-
able and faultless operation.
• Use the device only as intended.
english
4
4. basic safeTy
insTrucTiOns
These safety instructions do not make allowance for any:
• Contingencies and events which may arise during the instal-
lation, operation and maintenance of the devices.
• Local safety regulations – the operator is responsible for
observing these regulations, also with reference to the
installation personnel.
Danger – high pressure!
• Before loosening the pipes and valves, turn off the
pressure and vent the pipes.
Risk of electric shock!
• Before reaching into the device or the equipment,
switch off the power supply and secure to prevent
reactivation!
• Observe applicable accident prevention and safety
regulations for electrical equipment!
Risk of burns/risk of fire if used for a prolonged
switch-on time through hot device surface!
• Keep the device away from highly flammable substances
and media and do not touch with bare hands.
• Do not thermally insulate the unit and provide adequate
ventilation.
english
6
3.1.
•
•
/s.
2
•
•
3.2.
If exporting the system/device, observe any existing
restrictions.
Risk of short-circuit/escape of media through leaking
screw joints.
•
•
General hazardous situations.
To prevent injury, ensure that:
•
•
•
•
•

predictable misuse

The device may only be used in the explosion-protected
area if an appropriate additional identification is attached
to the rating plate.
Do not put any loads on the housing (e.g. by placing objects
on it or standing on it).
Do not make any external modifications to the device
housings. Do not paint the housing parts or screws.
The solenoid coil must not be thermally insulated, as it
heats up during operation. Ensure that the solenoid coil is
adequately ventilated.
restrictions
Ensure seals are seated correctly!
Carefully screw valve and connection lines together!
The system cannot be activated unintentionally.
Installation and repair work may be carried out by
authorized technicians only and with the appropriate
tools.
After an interruption in the power supply or fluid sup-
ply, ensure that the process is restarted in a defined or
controlled manner.
The device may be operated only when in perfect
condition and in consideration of the operating
instructions.
The general rules of technology apply to application
planning and operation of the device.
Type 6212
english
5
english
7