Appliance Description; Start-Up; Operation - Beurer FM 60 Mode D'emploi

Handling
CAUTION
The device must be switched off at the main switch and disconnected from the mains every time after
use and before cleaning.
• The appliance has a heated surface. Persons insensitive to heat must be careful when using the
appliance.
• Never insert any objects into openings on the device, and never insert anything into the rotating
parts. Make sure that all moving parts can move freely at all times.
• Never sit or stand on the moving parts of the device with all your weight and do not place objects
on the device.
• Keep the device away from high temperatures.

5. Appliance description

Shiatsu foot massager
3

6. Start-up

• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply.
• Set the main switch to 1.
• Route the cable safely so that there is no risk of anyone tripping over it.

7. Operation

Remove your shoes before each use. When seated comfortably, place your feet on the massage heads. The
device is prevented from slipping by the rubber feet on the base of the device.
Switch on the massager firstly at the main switch and then with the on/off button. To switch on the heat
function and the 2nd speed setting, press the on/off button again. Press on/off again to switch off the device.
For an optimum massage position, the rear feet can be adjusted. Rotate the feet higher in a clockwise direc-
tion or lower in an anti-clockwise direction.
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the
contact pressure if you find it is painful or unpleasant.
1
2
4
11
1 Massage surface with 9 Shiatsu massage
heads
2 Main switch
0 Off
1 On
3 Button
Press 1x: shiatsu massage
Press 2x: 2nd speed setting with heat function
Press 3x: off
4 Height-adjustable feet