Technical Data - EINHELL FKS 22/315 D Mode D'emploi

Anl FKS 22-315 D SPK1 22.09.2005
GB
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
Idle mode
Sound pressure level LPA 90,6 dB(A) 78,1 dB(A)
Sound power level LWA 105,1 dB(A) 92,8 dB(A)
The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.

5. Technical data

AC motor 400 V 3
Power P S1 1800 W
S6 40% 2200 Watt
Idle speed n
0
Cutting-off wheel Ø 315 x Ø 30 x 3,6 mm
Number of teeth
Main Table size 800 x 350 mm
Sliding table dimensions 1000 x 300 mm
Sliding length max.
Cutting height max. 73 mm / 0°
49 mm / 45°
Height adjustment infinite 0 -73 mm
Tilting saw blade infinite 0° - 45°
Extractor socket
18
15:21 Uhr Seite 18
6. Before putting the machine into
operation
Unpack the bench-type circular saw and check it
for damage which may have occurred in transit.
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong base. The machine must stand
securely, i.e. the saw must be securely bolted to
the floor.
All covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
Important! Pull out the power plug before
carrying out any maintenance, resetting or
assembly work on the cutting-off machine!
7.1. Setting up the saw (Fig. 1-9)
Place the saw with the table facing down on a
flat surface.
Fasten the four legs (18) to the machine body on
the inside, using four screws (SW13) for each
leg. When you insert the legs make sure that the
lugs of the legs fit the shape of the mounts
provided.
Mount the four rubber feet (25) on the legs.
50Hz
Fasten the chassis (15) to the legs on the inside,
using two screws for each leg. In doing so, the 4
spacers (26) must be inserted between the legs
2750 min -1
and the angle bracket (22) of the chassis. When
assembling, make sure that the rounded side of
24
the angle bracket faces the bottom of the
machine.
Turn the saw upside down and place it on the
floor.
600 mm
Carefully insert the sliding table (3) in the
slideways (24) and push to the point where the
locking hook (10) latches home.
Screw the mount for the extractor hose (29) and
the tool hook (28) to the machine body (see Fig.
6 and 7).
Ø 100 mm