Installing The Holders And The Steering Remote - Pioneer AVIC-900DVD Manuel D'installation

Installing the holders and the steering remote control
Note:
• When the unit is installed on a right-hand-drive car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt.
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Belt
3. Install outer holder on the inner
holder and secure with screws.
• Tighten the screws with the supplied hexago-
nal wrench.
Screw
Outer holder
2. Cut the extra portion of the belt at
Inner holder
4. Install the remote control unit in
the center of the inner holder.
the holder.
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Release Section
24