Kenwood KHC29 Mode D'emploi page 13

Food Processor
17
a
Small pusher
b
Large pusher
c
Feed tube
d
Lid
e
Bowl
f
Drive shaft
g
Knife blade
Discs (if supplied)
h
Thick slicing/grating disc
i
Thin slicing/grating disc
j
Extra fine grating disc
k
Thin julienne style chipper disc
l
Standard chipper disc
m
Extra thick grating disc
Assemble the Food Processor as shown
17
in illustration
1 Place the drive shaft onto the outlet.
2 Fit the bowl over the drive shaft with
the handle above the speed control
and turn clockwise until it locks into
position.
3 Fit either the knife blade, one of the
discs or the citrus juicer. The knife
blade and cutting section of the
discs are sharp so always handle
with care.
Hints and Tips
Cut meat, bread and vegetables
into 2cm cubes before processing.
Herbs are best chopped when
clean and dry.
Take care not to over process
when using the knife blade.
Do not use knife blade to chop ice
cubes or other hard foods such
as spices, they may damage the
attachment.
If adding almond essence or
flavouring avoid contact with
plastic as this may stain.
Discs
1 Choose which feed tube you want to
use. The pusher contains a smaller
feed tube for processing individual
items or thin ingredients.
2 Put the food into the feed tube.
3 Switch on and push down evenly
with the pusher - never put your
fingers in the feed tube.
To use the small feed tube - put the
large pusher inside the feed tube first.
To use the large feed tube - use both
pushers together.
Do not let the bowl fill up as far as
the cutting disc: empty it regularly.
Do not exceed the 'MAX' capacity
level on the bowl.
Hints and Tips
When using the reversible discs
ensure that the required cutting
side is uppermost.
Use fresh ingredients.
Do not cut food up too small. To
stop food slipping over during
processing fill the width of the large
feed tube or use the small feed
tube.
When slicing or grating: food
placed upright comes out shorter
than food placed horizontally.
After use there will always be a
small amount of waste on the disc
or in with the food.
Citrus Juicer
18
a
Cone
b
Sieve
Note: This attachment can only be used
in conjunction with the food processor
AT284.
Assemble the Citrus Juicer as shown in
18
illustration
1 Fit the sieve into the bowl ensuring
that the tab on the rim locks into the
bowl handle.
2 Fit the cone over the drive shaft
turning until it drops all the way down.
3 Cut the fruit in half. Switch to
speed 3 and press the fruit onto the
cone.
9