Safety Regulations; Layout And Items Supplied - EINHELL DSS 312 Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Take suitable precautions to protect yourself and
your environment from potential hazards.
•
Never put the impact screwdriver to any use
other than that intended. Keep pneumatic
tools safe from children.
•
Always concentrate while you work. Do not
work if you are tired.
•
Use only a quick-release coupling to connect
up the air supply.
•
It is imperative to use a pressure reducer to
set the working pressure.
•
Never use oxygen or combustible gases as
an energy source.
•
Always disconnect the tool from the air supply
before carrying out any repairs or mainte-
nance work.
•
Use only original replacement parts.
•
Never allow the tool to run unloaded at full
idle speed for any length of time.
•
Wear the necessary protective clothing when
working with the impact screwdriver.
•
Wear ear-muffs and safety gloves!
•
Compressors and lines reach high tempera-
tures during operation. Avoid contact! Risk of
burns!
•
Gases or vapours drawn in by the compres-
sor have to be kept free of constituents that
Anl_DSS_312_SPK7.indb 11 Anl_DSS_312_SPK7.indb 11
GB
may cause fire or explosions inside the com-
pressor.
•
When you disconnect the hose coupling, hold
the coupling element in your hand to prevent
injury from the whiplashing hose.
•
Wear goggles when working with the blow-
out gun. Injuries may easily result from foreign
bodies and blasted parts.
•
Never point the blow-out gun at other persons
and never use it to clean clothes that are still
being worn.

2. Layout and items supplied

2.1 Layout
1 trigger lever
2 air regulator / torque regulator
3 selector pin Forward/Reverse
4 square drive for nut socket (mounting shaft)
5 plug-on nipple for the air supply
6 Adjustment screw
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions
- 11 -
12.02.16 08:13 12.02.16 08:13