Electrolux SB339NCN Notice D'utilisation page 56

56 www.electrolux.com
Problem
Audible or visual alarm is
on.
A square symbol is shown
instead of numbers on the
Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
The compressor does not
start immediately after
pressing the Shopping‐
Mode, or after changing
the temperature.
Water flows inside the re‐
frigerator.
Possible cause
The cabinet has been re‐
cently switched on or the
temperature is still too
high.
The temperature in the
appliance is too high.
Temperature sensor prob‐
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function
is switched on.
The ShoppingMode func‐
tion is switched on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Solution
Refer to "Door Open
Alarm"or "High Temperature
Alarm".
Refer to "Door Open
Alarm"or "High Temperature
Alarm".
Contact the nearest Author‐
ised Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func‐
tion".
Refer to "ShoppingMode
function".
The compressor starts after
a period of time.
The compressor starts after
a period of time.
Clean the water outlet.