Use - DS Produkte VC-S1001B Mode D'emploi

Use as a fl oor vacuum cleaner
1

Use

CAUTION!
■ Only switch on the device once all parts have been fully fi tted and the dust container
and the fi lters are correctly
1. Depending on whether you would like to use the vacuum cleaner as a handheld
vacuum cleaner or fl oor vacuum cleaner, insert the handle bar (1) or remove it (see
"Use as a fl oor vacuum cleaner").
2. Attach the nozzle you want (see "Attaching / Detaching Accessories").
3. Unwind the mains cable to its full length.
4. Insert the mains plug into a properly installed plug socket that is easily accessible.
5. Move the On / Off switch (6) to position I to switch on the device.
6. Guide the nozzle over the surface to be cleaned.
7. To switch off the device, move the On / Off switch (6) to the 0 position.
8. Remove the mains plug from the plug socket after use.
17
1. Open the latch (12) for the handle bar on the
motor unit.
2. Push the handle bar into the receptacle on
the motor unit until the latch for the handle
bar locks in. To remove the handle bar, you
must open the latch by pulling it back and
2
then pulling the handle bar out.
3. Insert one of the cleaning heads, turbo nozzle (10) or fl oor
nozzle (13), in the suction opening on the dust bin.
inserted.
ATTENTION! Make sure that
the latch correctly locks into
place to prevent the handle
from slipping out!
EN