VOLTCRAFT VC280 Mode D'emploi page 51

Never operate the measurement device when it is open. !RISK OF FATAL INJURY!
Do not leave flat batteries in the device. Even batteries protected against leaking can
corrode and thus release chemicals which may be detrimental to your health or destroy
the battery compartment.
Do not leave batteries lying around carelessly. They could be swallowed by children
or pets. If swallowed, consult a doctor immediately.
Remove the batteries if the device is not used for longer periods of time to prevent
leaking.
Leaking or damaged batteries may cause alkali burns if they come in contact with
the skin. Therefore, use suitable protective gloves.
Make sure that the batteries are not short-circuited. Do not throw batteries into the
fire.
Batteries must not be recharged or dismantled. Danger of explosion!
You can order suitable alkaline batteries stating the following order no.:
Item no. 65 25 09 (please order one).
Only use alkaline batteries, as they are powerful and have a long service life.
Proceed as follows to insert/replace the CLA40 probe converter batteries:
- Disconnect the measuring adapter from the measuring object and the connected measuring lines
from your measuring device. Switch off the adapter (OFF).
- Open the rear battery compartment with a suitable
screwdriver and remove the battery compartment
lid.
- Replace the flat batteries with new one of the same
type. Insert the new batteries in the battery compart-
ment (23) observing the correct polarity. Observe the
correct polarity indicated in the battery compartment.
- Now close the housing carefully again.
You can order suitable alkaline batteries stating the following order no.:
Order no.: 65 23 03 (please order 2).
Only use alkaline batteries, as they are powerful and have a long service life.
51