Connect The Surround Back Or Front Height Speakers; Making Cable Connections - Pioneer VSX-520-S Mode D'emploi

Connecting your equipment
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Make sure that all the bare speaker wire is
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause
the power to cut off as a safety measure.
Connect the surround back or front
height speakers
Connect the PRE OUT outputs of the unit and
additional amplifier to add a surround back or
front height speaker.
• If the surround back speaker or the front
height speaker is connected, set the Pre
Out setting (see The Pre Out Setting on
page 42).
Surround back or
front height speakers
SBL/FHL SBR/FHR
BD
DVD
• You can use the additional amplifier on the
surround back channel pre-outs for a
single speaker as well. In this case plug the
amplifier into the left (L (Single)) terminal
only.
Surround back or
front height
channel amplifier
ANALOG
INPUT
L R
SUBWOOFER
PRE OUT
CD-R/TAPE DVR/VCR
ADAPTER
SURR BACK /
FRONT ( OUTPUT 5 V
HEIGHT
L
( Single )
OUT
R
PRE OUT
CD CD-R/TAPE DVR/VCR
L

Making cable connections

Make sure not to bend the cables over the top
of this unit (as shown in the illustration). If this
happens, the magnetic field produced by the
transformers in this unit may cause a
humming noise from the speakers.
Important
• Before making or changing connections,
switch off the power and disconnect the
power cord from the AC outlet.
• Before unplugging the power cord, switch
the power into standby.
1
03
19
En