Step1: Connect The Speakers - Pioneer SX-N30AE Mode D'emploi

> Before Start > Part Names

Step1: Connect the Speakers

Install
1/2˝
(12 mm)
a Speaker Cable
8
> Install
a
*
Right Left
Speaker A
> Initial Setup > Playback
a
Left
Right
Speaker B
Supplementary information | Advanced Setup | Others
You can connect two systems, Speaker A and Speaker B,
as the Speaker System. When connecting only one set,
connect to the SPEAKERS A terminals. With one set, use
speakers with 4 ≠ to 16 ≠ impedance. Note that when
connecting to both SPEAKERS A and B terminals, connect
speakers with 8 ≠ to 16 ≠ impedance to both A and B.
Connect the speaker cable so the wires do not protrude
from the speaker jacks. If the exposed wires of the
speakers touch the rear panel or the + and - wires touch
each other, the protection circuit will be activated.
Setup
0 When connected as a Speaker B System, you
can output the same audio as Speaker A System
by switching with A/B/A+B. Press SPEAKER A/B
on the remote control to switch. The selection
changes in the order SPEAKER A, SPEAKER B,
SPEAKER A+B with each press.
0 If any of the connected speakers have an
impedance of 4 ≠ or more to less than 6 ≠, or
when speaker systems are connected to both of
the SPEAKERS A/B terminal, after completing
Initial Setup, you need to make some settings in
the Setup menu. Press SETUP on the remote
controller, and set "3. Hardware" - "SpImpedance"
to "4≠". (P28)
(*)You can also connect a subwoofer with a built-in
amplifier to the SUBWOOFER PRE OUT jack to boost
bass playback even more. Use a subwoofer cable for
connection. When only Speaker B is outputting audio,
there will be no audio output from the powered
subwoofer.