Connect The Speakers - Pioneer SX-S30DAB Mode D'emploi

> Before Start > Part Names

1. Connect the Speakers

Install
1
1
2
1/2˝
(12 mm)
3
a
3
b
a Speaker cable, b Subwoofer cable
> Install > Initial Setup
2
4
> Playback
Advanced Setup | Firmware Update | Others
Refer to the illustration to connect the speaker system.
Twist the wires of the speaker cable tightly before inserting
into the SPEAKERS terminals. After inserting the cables,
tighten the terminals firmly by turning to the right. Make
correct connection between the unit's jacks and speaker's
jacks (+ to + and – to –) for each channel. If connection is
wrong, a bass sound may become poor due to reverse
phase.
To connect a powered subwoofer, use a subwoofer cable
and connect to the SUBWOOFER PRE OUT jack.
Make sure the exposed wires of the speaker cable do not
stick out of the speaker terminals when connecting. If the
exposed wires of the speaker cable touch the rear panel or
the + and – wires touch each other, the protection circuit will
be activated. ( P49)
Setup
0 Settings for the speaker configuration you have connected
need to be made in "1. Full Auto MCACC" (
Setup.
E
N
P13) in Initial
7