Pioneer SX-S30DAB Mode D'emploi page 43

> Before Start > Part Names
in "AV Adjust" - "MCACC" - "Manual EQ Select" (
Front Left After selecting the speaker frequency from between "63 Hz" and
"16 kHz" with the cursors
frequency between "-12.0 dB" and "+12.0 dB" with / . (Default
Value is "0.0 dB")
0 "63 Hz" can only be selected when this speaker is set to
"Large" in "System Setup" - "Speaker" - "Crossover" (
Front Right After selecting the speaker frequency from between "63 Hz" and
"16 kHz" with the cursors
frequency between "-12.0 dB" and "+12.0 dB" with / . (Default
Value is "0.0 dB")
0 "63 Hz" can only be selected when this speaker is set to
"Large" in "System Setup" - "Speaker" - "Crossover" (
Subwoofer After selecting the speaker frequency from between "31 Hz" and
"250 Hz" with the cursors
frequency between "-12.0 dB" and "+12.0 dB" with / . (Default
Value is "0.0 dB")
0 This cannot be selected if "No" is set in "System Setup" -
"Speaker" - "Configuration" - "Subwoofer" (
0 The result may not be as expected depending on the input source and listening mode
setting.
0 If you want to make the adjustments while listening to something, press
controller, and select the Preset you want to adjust in "AV Adjust" - "MCACC" - "Manual
EQ Select" ( P29) first.
42
> Install > Initial Setup
P29).
/ , adjust the volume of that
P33).
/ , adjust the volume of that
P33).
/ , adjust the volume of that
P33).
on the remote
> Playback
MCACC Data Check
You can check the number of speaker channels connected and the content and values you
have set for each of the speaker settings.
∫ Speaker Setting
You can check the number of speaker channels connected and the large and small settings
you have set for the low range reproduction capabilities for each of the speakers.
∫ Channel Level
You can check the output level settings for each of the speakers.
∫ Speaker Distance
You can check the distance from each speaker to the listening position.
∫ Acoustic Calibration EQ
You can check the calibration values for the frequency characteristics of each speaker that
were set in "Manual MCACC".
Advanced Setup | Firmware Update | Others
E
N