Rear Panel - Pioneer SX-N30AE Mode D'emploi

> Before Start > Part Names


Rear Panel

1. DIGITAL IN OPTICAL/COAXIAL jacks: Input digital audio signals from an external device
with a digital optical cable or digital coaxial cable.
2. USB jack: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (maximum 5 V/1 A) to USB devices with a USB cable.
3. LAN (10/100) jack: Connect to the network with an Ethernet cable.
4. Wireless antenna: Raise for Wi-Fi connection or when using a BLUETOOTH wireless
technology enabled device. Adjust their angles according to the connection status.
5. FM UNBAL 75≠/AM LOOP ANTENNA jacks: Connect the supplied FM indoor antenna
and AM indoor antenna.
6. Power cord
7. SIGNAL GND jack: The ground wire of the turntable is connected.
8. LINE IN jacks: Input audio signals from an external device with an analog audio cable.
6
> Install > Initial Setup
   
  
> Playback

 
9. LINE OUT jacks: Connect a recording device, such as a cassette tape deck. Connect to
the LINE IN jacks on the recording device using analog audio cable.
10.SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a subwoofer cable.
11. SPEAKERS jacks: Connect speakers with speaker cables. You can connect a set of left
and right speakers to each of the A/B terminals.
Supplementary information | Advanced Setup | Others

90°

180°