Rear Panel (N-70Ae) - Pioneer N-70AE Manuel D'instructions

> Before Start > Part Names
Rear Panel
(N-70AE)
1. ANALOG OUT jack: Use the supplied analog audio cable or a commercially available
XLR cable to connect an integrated amplifier, for example.
2. Wireless antenna jack: Connect the supplied wireless antenna to connect wirelessly. After
firmly attaching the antenna, adjust the angle according to the connection status.
0 When re-packaging the unit, etc., remove the wireless antenna to prevent damage.
3. DIGITAL OUT OPTICAL/COAXIAL jack: Use a digital optical cable or digital coaxial cable
to connect an integrated amplifier, for example.
4. DIGITAL IN OPTICAL/COAXIAL jack: Use a digital optical cable or digital coaxial cable to
connect a CD player, for example.
5. AC IN: Connect the supplied power cord.
6. CONTROL OUT jack: By connecting Pioneer brand amplifiers and CD players,
centralized control is possible, for example you can control the amplifiers and CD players
from the Pioneer Remote App.
7. USB DAC port: Use a USB cable (A—B type) to connect a computer.
8. USB port: Connect a USB storage device or HDD (hard disk drive) to play music files. You
can also supply power (maximum 5 V/1 A) to USB devices with a USB cable. It is also
possible to save or delete music files on the USB HDD with a computer over the network.
> Install > Initial Setup
  

> Playback
Supplementary information | Advanced Setup | Others
 
  
( P21)
9. NETWORK jack: Connect to the network with an ethernet cable.


E
N
5