Pioneer VSX-520-S Mode D'emploi page 15

Controls and displays
HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCR recorders.
SB CH
Press to select ON, AUTO, OFF the
surround back channel.
CH SELECT
Press repeatedly to select a channel, then
use LEV +/– to adjust the level (page 41).
LEV +/–
Use to adjust the channel levels.
MIDNIGHT
Switches to Midnight or Loudness
listening (page 35).
SPEAKERS
Use to change the speaker system on or
off. When the SP OFF is selected, no sound
is output from the speakers connected to
this receiver.
DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.
12  SOURCE
Turns on or off the power of the Pioneer DVD/
DVR units when BD, DVD, DVR or CD is
selected using the MULTI CONTROL buttons.
13 TV CONTROL buttons
These buttons can control only be used with
Pioneer TVs.

Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
Note
1 The Pre Out setting may or may not be displayed, depending on the input source you have selected.
DTV/TV*
Switches between the DTV and analog TV
input modes for Pioneer TVs.
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes/unmutes the sound.
16 DISP
Switches the display of this unit. The listening
mode, sound volume, Pre Out setting or input
name can be checked by selecting an input
1
source.
17 SHIFT
Press to access the 'boxed' commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (* ) in this section.
02
15
En