IWC Schaffhausen AQUATIMER AUTOMATIC 2000 Mode D'emploi page 31

Removing and fitting the rubber strap
28 | 29
The identical attachment for the rubber strap lets you
use the same strap replacement procedure as when
handling the metal bracelet. To remove the rubber strap,
push down the securing pin situated on the case and
slide the pivot pin from the case at the same time. Pull
the protruding pivot pin from the case. The strap is now
separated from the case. Fit the strap using the same
procedure as when joining the metal bracelet. When
fitting the strap, make sure that the pivot pins are secure
to prevent the watch from being lost.
Status December 2004.
Technical specifications subject to change.