Names Of The Parts; Before Use - IKRA ULTRA LIGHT FHS 1545 Mode D'emploi

Names of the parts

5
6
1 Safety blades
2 Protection shield
3 Wrap-around handle with ON/OFF switch
4 Rear handle with ON/OFF switch
5 Power cord connecteur
6 Strain relief
7 Protective blade cover
8 Impact protector (only FHS 1555)

Before use

Power connection
The machine can only be connected to a single-phase
a.c. current connection. The machine is protectively in-
sulated in accordance with classification II of VDE 0740.
Before using the machine ensure that the mains current
agrees with the operating voltage data on the machine's
identification plate.
Power Circuit Breaker
Machines which will be used in different outside
locations must be connected to a Power Circuit
Breaker.
Securing the power supply cable
Use only extension cords that are approved
for outdoor use and are not lighter than
rubber-sheathed cables of type H07 RN-F ac-
cording to DIN/VDE 0282 with a diameter of at
least 1.5 sq. mm. They cords must be splash-
proof. If the connection cable of this device
should be damaged it must be replaced by a
workshop named by the manufacturer only
as this work requires the use of special tools.
GB | Operating Instruction
4
3
2
7
• First connect the device plug with the connection line.
Form a narrow loop with the connecting cable, press
on the button and swivel the cable holder (X) out into
position A.
• Now insert the loop of cable from below into the mains
lead cleat. Once you have released the cable hook
button, it will automatically return to starting position
B and the cable will be held in place.
5
1
A
X
8