Inserting Batteries; Setting The Clock; About The Power Management - Sony MHC-ECL99BT Mode D'emploi

When carrying this system
Make sure that there is no disc loaded
and no USB device is connected, and
remove the power cord from the wall
outlet.

Inserting batteries

Insert an R6 (size AA) battery
(supplied), matching the polarity
shown below.
Notes on using the remote control
ˎ With normal use, the battery should last
for about six months.
ˎ If you do not use the remote control for a
long period of time, remove the battery to
avoid damage from battery leakage and
corrosion.

Setting the clock

1
Press  to turn on the
system.
2
Press TIMER MENU to select
the clock set mode.
If "SELECT" appears, press  / 
repeatedly to select "CLOCK," and
then press (ENTER).
3
Press / repeatedly to set
the hour, then press
4
Use the same procedure to
set the minutes.
Notes
ˎ The clock settings are lost when you
disconnect the power cord or if a power
failure occurs.
ˎ When setting the clock, select a function
other than the audio in function
beforehand.
To display the clock when the
system off
Press DISPLAY. The clock is displayed
for a few seconds.
About the power
management
By default, this system is set to turn
off automatically in about 15 minutes
when there is no operation, and no
audio signal is detected. For details,
see "To turn off the automatic standby
function" (page 33).
.
11
GB