Installation And Connection; Placement Of Your Oven - Panasonic NN-K354WM Mode D'emploi

Installation and connection

Examine your microwave oven
Unpack the oven, remove all packing
material, and examine the oven for any
damage such as dents, broken door
latches or cracks in the door. If you
find any damage, notify your dealer
immediately. Do not install a damaged
microwave oven.
Earthing instructions
„ Important!
THIS UNIT HAS TO BE PROPERLY
EARTHED FOR PERSONAL SAFETY.

Placement of your oven

This oven is intended for counter-top use
only. It is not intended for built-in use or
for use inside a cupboard.
1. Place the oven on a flat and stable
surface more than 85 cm above the
floor.
2. When this oven is installed, it should
be easy to isolate the appliance
from the electricity supply by pulling
out the plug or operating a circuit
breaker.
3. For proper operation, ensure a
sufficient air circulation for the oven.
Counter-top use:
Allow 15 cm of space on the top of
the oven, 10 cm at the back, 5 cm on
one side, and the other side must be
opened more than 40 cm.
5 cm
15 cm
10 cm
open
If your AC outlet is not grounded, it is the
personal responsibility of the customer to
have it replaced with a properly grounded
wall socket.
Operation voltage
The voltage has to be the same as
specified on the label on the oven. If a
higher voltage than specified is used, it
may cause a fire or other damages.
4. Do not place this oven near an
electric or gas cooker range.
5. The power cord should not touch
the outside of the oven. Keep the
cord away from hot surfaces. Do not
let the cord hang over the edge of a
table or work top. Do not immerse
the cord, plug or oven in water.
6. The feet should not be removed.
7. This oven is only for household
usage.
Do not use outdoors.
8. Avoid using the oven in high
humidity.
9. Do not block the air vents on the
top, sides and back of the oven. If
these openings are blocked during
operation the oven may overheat. In
this case the oven is protected by a
thermal safety device and resumes
operation only after cooling down.
10. This appliance is not intended to be
operated by means of an external
timer or separate remote-control
system.
6
EN