General Information; How To Read The Manual - Stiga ST 526 S Manuel D'utilisation

1. GENERAL INFORMATION

1.1 HOW TO READ THE MANUAL

Some paragraphs in the manual contain
important information regarding safety
and operation and are emphasized in
this manner:
NOTE or IMPORTANT these give
details or further information on what
has already been
said, and aim to prevent damage to the machine.
The symbol highlights danger. Non-
compliance with the warning could lead
to personal and/or third party injury and or
damage.
Whenever reference is made to a position
on the machine "front", "back", "left" or
"right" hand side, this refers to the
operator's working position.
1.2 REFERENCES
1.2.1 Figures
The figures in these
instructions for use are
numbered 1, 2, 3, etc.
Components shown in the
figures are marked A, B, C,
etc.
A reference to component C in
figure 2 is written: "See fig. 2.C" or
simply "(Fig. 2.C)". The figures are
given as a guide only. The actual
parts may vary from those shown.
1.2.2 Titles
The manual is divided into chapters
and paragraphs. The title of paragraph
"2.1 Training" is a sub-title of "2. Safety
regulations". References to titles or
paragraphs are marked with the
abbreviation chap. or par. and the
relevant number. Example: "chap. 2" or "par.
2.1".
The paragraphs highlighted in a square with
grey spots indicate the optional characteristics
not on all models documented in this manual.
Check if the characteristic is on this model.
EN - 2