Specifications - Sony TA-VE610 Mode D'emploi

Additional Information

Specifications

Amplifier section
POWER OUTPUT
Stereo mode
(4 ohms at 1 kHz, THD 0.7%)
100 W + 100 W
Surround mode (4 ohms at 1 kHz, THD 0.7%)
Front: 100 W/ch
Center
Rear
*
Depending on the sound field settings and the
source, sound will not be output.
5.1 mode (4 ohms at 1 kHz, THD 0.7%)
Front: 100 W/ch
Center: 100 W
Rear: 100 W/ch
Harmonic distortion at rated output
Less than 0.09% (with DIRECT PASS on)
Frequency response
PHONO: RIAA equalization curve
±0.5 dB
CD, TAPE/MD, VIDEO 1, 2:
10 Hz - 50 kHz
Inputs
PHONO
CD
TAPE/MD, VIDEO 1, 2,
3, TV/LD, TUNER
5.1 INPUT
*
'78 IHF
Outputs VIDEO 1, 2 AUDIO OUT:
Voltage: 150 mV
Impedance: 10 kilohms
WOOFER:
Voltage: 2 V
Impedance: 1 kilohms
PHONES:
Accepts low and high impedance headphones
BASS BOOST
+10 dB at 70 Hz
TONE ±8 dB at 100 Hz and 10 kHz
Video section
Inputs 1 Vp-p 75 ohms
Outputs 1 Vp-p 75 ohms
EN
22
*
: 100 W
*
: 100 W/ch
+0
dB (with DIRECT PASS on)
–1
S/N (weighting
network, input
Sensitivity Impedance
level)
2.5 mV 50 kilohms
(A, 2.5 mV)
200 mV 50 kilohms
(A, 200 mV)
150 mV 50 kilohms
(A, 150 mV)
200 mV 50 kilohms
(A, 150 mV)
General
System
Power requirements
Power consumption
AC outlets
Dimensions
Mass (Approx.) 9.8 kg
Supplied accessories
Design and specifications are subject to change without
notice.
*
75 dB
*
82 dB
*
82 dB
*
82 dB
Preamplifier section:
Low-noise NF type equalizer
Power amplifier section:
Pure-complementary SEPP
230 V AC, 50/60 Hz
240 W
1 switched, maximum
100 W
430 × 155 × 350 mm
including projecting parts and controls
See page 4.