Maintenance; Specifications - Sony XM-1ES Mode D'emploi

Maintenance

Fuse Replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse.
If the fuse blows, check the power connection and
replace the fuse.
If the fuse blows again after replacement, there
may be an internal malfunction. If this happens,
consult your nearest Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the amplifier as
this could damage the amplifier.

Specifications

FOR THE CUSTOMERS IN THE USA.
POUR LES CLIENTS AUX ÉTATS-UNIS.
AUDIO POWER SPECIFICATIONS
CTA2006 Standard
Power Output:
600 Watts RMS × 1 Channel at 4 Ohms
and ≤ 1% THD+N, 1,000 Watts RMS × 1
Channel at 2 Ohms and ≤ 1% THD+N
Circuit system:
Class D Technology circuit
Pulse power supply
Inputs:
RCA pin jacks
Input level adjustment range:
0.2 V – 8 V (RCA pin jacks)
3 V – 16 V (high-level input)
Outputs:
Speaker terminals
RCA pin jacks
Speaker impedance:
2 Ω – 8 Ω
Maximum output:
1,550 W (at 2 Ω)
1,000 W (at 4 Ω)
Rated output:
1,000 W RMS (100 Hz 1.0% THD+N, at 2 Ω)
600 W RMS (100 Hz 1.0% THD+N, at 4 Ω)
Frequency response:
10 Hz – 500 Hz (
THD (total harmonic distortion):
0.05% or less (100 Hz)
Low-pass filter
50 Hz – 500 Hz, 24 dB/oct
Subsonic filter
5 Hz – 50 Hz, 24 dB/oct
Power requirements:
12 V DC car battery (negative ground (earth))
Power supply voltage:
10.5 V – 16 V
Current drain:
At rated output: 90 A (2 Ω, 1,000 W × 1)
Remote input: 4 mA
dB)
15
GB