LINE OUT MODE switch
Sets the mode of signal output to the LINE OUT 1
and 2 connectors. Signal output from the LINE
OUT connectors are unfiltered and not affected
by any filter settings.
"THRU": Outputs stereo signal from the INPUT
1 connector to the LINE OUT 1 connector, and
from the INPUT 2 connector to the LINE OUT 2
connector.
"ALL": Outputs the summed mono signal.
Sums the input signals (INPUT 1+2) and
outputs to the LINE OUT 1 and 2 connectors.
SUBSONIC FILTER switch
Turns the subsonic filter on or off.
SUBSONIC FILTER control
Adjusts the cutoff frequency (5 Hz – 50 Hz) of the
subsonic filter.
Connector Panel (Front Panel)
BASS
INPUT
REMOTE
VOLTAGE
L
LOW HIGH
R
BASS REMOTE connector
Connector for the bass remote.
INPUT VOLTAGE switch
Selects the type of input connection.
"LOW": Select this for low-level (line level)
input connection using RCA extension cables
(not supplied).
"HIGH": Select this for high-level (speaker
level) input connection using a speaker-wire-
to-RCA adaptor (not supplied).
INPUT connector
For details about the connection, see "Input
Connection" (page 12).
6
GB
INPUT
LINE OUT
1
1
SPEAKER OUT
2
2
LPF (low-pass filter) switch
Turns the low-pass filter on or off.
LPF (low-pass filter) control
Adjusts the cutoff frequency (50 Hz – 500 Hz) of
the low-pass filter.
INPUT SENS (input sensitivity) control
Adjusts the input level sensitivity.
Turn the knob clockwise when the output level
of the connected audio devices is low.
SPEAKER OUT terminal screw head
+12 V terminal screw head
REMOTE terminal screw head
GROUND terminal screw head
25 A
25 A
25 A
25 A
LINE OUT connector
For details about the connection, see "Output
Connection" (page 14).
SPEAKER OUT terminal
For details about the connection, see "Speaker
Connection" (page 13).
Fuse (25 A)
+12 V terminal
REMOTE terminal
GROUND terminal
+
12 V
REMOTE
GROUND