Connecting The Cooling Device - Dometic CF11 Notice D'utilisation

CoolFreeze
6.3 Locking the cooling device
➤ Close the lid.
➤ Press the latch (fig. 4 or fig. 5 1, page 4) down, until it latches in
place audibly.
6.4

Connecting the cooling device

The cooler can be operated with
12 Vg or 24 Vg or 100 – 240 Vw.
A
NOTICE! Danger of Damage!
• Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
• Overvoltage can damage the electronics of the device.
➤ Place the cooler on a firm base.
Make sure that the ventilation slots are not covered and that the heated air can be
dissipated.
Connecting to a battery (vehicle or boat)
A
NOTICE!
For protection of the device the DC cable supplied includes a fuse inside
the plug. Do not remove the fused DC plug. Only use the DC cable sup-
plied.
I
NOTE
If you connect the cooler to the DC socket, remember that the ignition
must be turned on to supply it with power.
➤ Plug the DC connection cable (fig. 6 2, page 4) into the DC voltage inlet of the
cooler (fig. 3 3, page 3).
➤ Connect the connection cable to the DC power outlet.
EN
Operation
13