Maintenance; Maintenance Schedule - Husqvarna LC 353AWD Manuel D'utilisation

Masquer les pouces Voir aussi pour LC 353AWD:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 132
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover *
Examine the engine brake handle *
Examine the blade brake control *
Examine the muffler *
Examine the spark plug
Replace the oil (the first time after 5 h of use, then after each 50 h of
use)
Clean or replace the air filter
Examine the fuel system
To do a general inspection
Make sure that all nuts and screws on the product
are tightened correctly.
To clean the product externally
Use a brush to remove leaves, grass and dirt.
Make sure that the air intake on the top of the engine
is not blocked.
Do not use a high pressure washer to clean the
product.
If you use water to clean the product, do not flush
water directly on the engine.
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
14
Maintenance

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 10 .
3. Hose down the inner surface of the cutting cover
with water.
To use the water hose connection
1. Move the product to an area of cut grass or a
different hard surface.
2. Remove the grass catcher or mulch plug from the
product.
3. Close the rear deflector.
4. Connect a water hose to the water hose connection.
(Fig. 40)
5. Stop the water supply and examine the water hose
connection for leaks.
CAUTION: Make sure that the air filter is up
and not against the ground when you tilt the
product. Risk of engine damage.
Daily
Weekly
X
X
X
X
X
X
X
X
X
CAUTION: If the product is put with the
air filter down, the engine can become
damaged.
1242 - 003 - 01.11.2019
Monthly
X
X
X

Publicité

Table des Matières
loading

Table des Matières