Operation - Sportplus SP TM 4220E Mode D'emploi

9. OPERATION

CAUTION
• Connect the power plug to a certified, grounded power outlet only.
• Before you start exercising, read through and follow all advices and instructions
mentioned in chapter "Training and operating instructions".
• We recommend to maintain a slow speed at the beginning of a session and hold on
to the handrails until you become comfortable and familiar with the treadmill.
• Fasten the safety key to your clothing before beginning training.
• To end your workout safely, press the STOP button or pull the safety key, then the
treadmill will stop immediately.
START-UP (MANUAL MODE)
1. Power on the treadmill using the power switch.
2. Connect the safety key to the computer.
3. Press the START button. Now the system enters into a 3 second countdown. The
buzzer emits a sound. The speed window displays the countdown. After 3 seconds,
the treadmill will start to run at a speed of 1.0 km/h.
4. After start-up, use the button SPEED+/- to adjust the speed.
5. You can press the INCLINE+/- button to adjust the incline.
6. Press the STOP button to stop the treadmill.
Note: When holding the pulse handles with two hands for about 5 seconds, the display
will show the pulse data.
AUTOMATIC DISPLAY SHUTDOWN
• If the treadmill is in idle state and no buttons have been pressed for 10 minutes, the
display will go out in order to save power.
• To prevent accidental operation, the computer can only start by removing and
reinserting the safety key or by switching the main switch on or off.
SAFETY KEY / EMERGENCY SWITCH
Important: Always attach the magnetic end of the safety key to the computer before you
start with the training. Fasten the safety key to your clothing before beginning training.
• If you pull the safety key during training, the treadmill will stop immediately.
• Attach the magnetic end of the safety key to the computer to continue the training.
FUSE
• In case the fuse has been triggered, push the RESET button.
• Check if the belt is lubricated sufficiently.
• Check if the belt's tension is sufficient.
SP-TM-4220E-IM-05-DE+GB+FR.indb 65
65
15/6/2016 18:46