Velleman CCTVPROM10 Notice D'emploi page 8

7.3.2 RECORD
Configure record parameters, enable/disable audio.
NOTE: Audio capable cameras (not included) are required for audio recording.
To configure recording options:
1) Under CHANNEL, use the drop-down menus and select ON/OFF to enable/disable recording from
the selected channel.
2) Under RESOLUTION, select HIGHEST, HIGH, or NORMAL (corresponding to D1, HD1, CIF
resolution).
NOTE: PAL: D1@6fps, HD1@12fps, CIF@24fps / NTSC: D1@7fps, HD1@15fps, CIF@30fps
3) Under QUALITY, select BEST,FINE, NORMAL
CIF: corresponding to 384Kbps and 512Kbps and 768Kbps.
HD1: corresponding to 512Kbps and 768Kbps and 1024Kbps.
D1: corresponding to 512Kbps and 768Kbps and 1024Kbps.
4) Under AUDIO, select ENABLE or DISABLE. If audio recording is enabled, the system will record
audio from connected audio capable cameras (not included).
5) Under REC. MODE, select POWER UP or TIMER RECORD. If you select POWER UP, the system
will record continuously (normal recording) when the system is powered on. If you select TIMER
RECORD, you have to set a recording schedule on the system.
6) Under REC. SIZE, select 15MIN, 30MIN, 45MIN, or 60MIN.
NOTE: Record size sets the file size for recorded video files on the system. Instead of recording
data as one large file, the system will divide the data into blocks of 15, 30, 45, or 60 minutes. This
makes the recorded data easier to search.
7) Click APPLY. Click SURE in the confirmation window.
8) Click EXIT in every menu until all windows are closed.
Recording Schedule
By default, the system is set to record continuously, 24 hours a day, 7 days a week. You can program
the system to record according to a customized recording schedule.
The schedule grid shows the days of the week and hours 0~23. You can set ALARM recording (red),
GENERAL (normal) recording (green), or MANUAL recording (blue) for each time block of each day.
To set a recording schedule:
1) Open the Main Menu and click RECORD.
2) Under REC. MODE, select TIMER RECORD.
3) Click SCHEDULE. The Schedule menu opens.
4) Under CHANNEL, select specific channels or select ALL.
5) Below the grid, click either ALARM (red), GENERAL (green), or MANUAL RECORD (blue) and
then click a time block on the desired day.
6) Use the FROM/TO drop-down menus to copy the schedule of one day to another.
12/04/2011
CCTVPROM10
Figure 2.4.2.3.1 Record
Figure 2.4.2.3.1 Recording Schedule
8
©Velleman nv