Basic Settings Of The Menu - Fhiaba 1T Mode D'emploi

How to check the status of the filter
It displays days and liters left before filter expi-
ration.
Reset Filter
The Reset Filter function sets to zero the time
left before the filter needs to be replaced. It is
necessary to set the meter to zero each time the
cartridge is replaced. As an alternative press for
5 seconds the Enter button
How to set the filtered water meter to zero
Bypass Filter
This function is to be activated when it is not
necessary to filter the water, because excellent
quality water is already available from the home
water system.
How to activate filter Bypass
How to deactivate filter Bypass
Manual Clean, Water Filter
If ice production has been disabled or unused for
a long period it is recommended to perform a Ma-
nual Clean function to flush out water which has
sat in the system during this period.
Before proceeding it is important to turn off the
ice maker by pressing button
How to manually clean the filter
.
www.fhiaba.com · info@fhiaba.com · Info Line 800-344222
Repeat the operation until the water is clean.
Correctly position the ice tray or another sui-
table container under the IceMaker to collect
water, then close the drawer. At the end of the
operation, wash the tray.

5.3 Basic settings of the Menu

Select the Menu button
button to select Settings .
TriMode Options
The freezer compartment can, if required, be con-
verted to the refrigeration o Fresco operating mode.
How to set the Fridge function
How to set the Fresco function
How to revert to the Freezer function
Default Setting
This offers the possibility to reset default factory
settings and cancels any previous changes.
How to reset default settings
Important
If the default settings are restored, the de-
fault mode of the TriMode compartment is
freezer mode. If it was previously being
used in refrigerator or Fresco mode be sure
to set it back to your desired setting.
and used the Up/Down
15
EN