Fhiaba 1T Mode D'emploi page 25

mation of condensation.
In any case, make sure that the doors are always
perfectly closed.
Ice or frost build up inside the refrigerator
or freezer
Did you leave the doors open for a long period of
time?
Do the doors close perfectly?
If the doors do not close perfectly, contact your in-
staller.
In case of frost or ice build up in the Crisper-Fresco
compartment, due to frequent and prolonged open-
ing of the doors, deactivate the Crisper-Fresco func-
tion via the button on the control panel. Wait until the
frost or ice melt, then remove the drawer and dry the
sides and bottom of the compartment.
Unpleasant odors inside the refrigerator
Clean the appliance completely according to the in-
structions.
Hermetically cover all the food. Do not conserve food
for prolonged periods of time.
The doors are difficult to open
The appliance is designed to ensure a fully hermetic
closure. When the door is closed, a vacuum condition
can occur: in this case it is necessary to wait a few
seconds until the pressure balances before opening
the door.
Appliance is cooling but lights and display are not
working
Check to see if the appliance was accidently placed
into Sabbath Mode
The Ice Maker does not work
Make sure that the Ice Maker is on (Icemaker button
on).
To switch on the Ice Maker press the button.
Make sure that the appliance is connected to the wa-
ter supply.
The Ice Maker does not produce sufficient amounts
of ice
On average, the Ice Maker produces approximately
10 cubes of ice every two and half hours.
The ice cubes freeze into one block
If the ice is not used frequently, it is possible that
blocks of ice may form. It is recommended to remove
the block of ice cubes and then let the Ice Maker fill
the ice tray again.
The ice has an unusual flavour or colour
When the Ice Maker is started for the first time, it
is recommended to empty the first full tray of ice
cubes.
www.fhiaba.com · info@fhiaba.com · Info Line 800-344222
If the refrigerator was switched off for more than
one month or if the cartridge was not changed for
more than six months, it could be necessary to re-
place the filter cartridge.
Contact a plumber or a water treatment expert to
make sure that the problem is not due to the water
supply.
If the unit you purchased was used as a
showroom model it may be in a special en-
ergy-saving mode called Demo Mode where
the appliance appears to be operating (lights
work and false temperatures are displayed)
but no cooling actually takes place. If you
suspect your appliance is in Demo Mode
please contact your point of purchase for as-
sistance with disabling this feature.
EN
25