Caring For The Environment; Cleaning, Sanitization And Maintenance Of The Ice And/Or Water Dispenser (If Present); Installation; Connection To The Water System - Fhiaba 1T Mode D'emploi

Symboles utilisés dans le manuel:
Note
conseils pour une correcte utilisation de
l'appareil
Important
Indications afin d'éviter tout
endommagement de l'appareil
Attention
indications afin d'éviter toute lésion aux
personnes

1.3 Caring for the environment

> Pay special attention to correct disposal procedu-
re for all the packaging materials.
> The appliance must not be disposed of with urban
waste. Contact local waste disposal centres for on
how to dispose of recyclable waste.
> Prior to disposal, cut the power supply cord and
make it impossible to close the door.
> During disposal, avoid damage to the refrigeration
circuit.
> The appliance does not contain hazardous sub-
stances for the atmospheric ozone layer, neither in
the refrigeration circuit nor in the insulation.
1.4 Cleaning, sanitization and maintenan-
ce of the ice and/or water dispenser (if
present)
Failure to follow the instructions regarding sani-
tizing can compromise the hygienic safety of the
water dispensed.
> When using the appliance for the first time and
every time the filter is changed, it is recommended
to let the water flow in the circuit using the "Ma-
nual Cleaning" and discard the ice produced in the
first 24 hours.
> If the water dispenser has not been used for
more than 4/5 days, it is advisable to clean the
circuit and run off the first litre of water.
> Reposition the removable water dispenser (if
present), ensuring your hands are hygienically
clean.
www.fhiaba.com · info@fhiaba.com · Info Line 800-344222

2. INSTALLATION

> Clean the ice bucket or drawer regularly but
using only drinking water.
> The filter must be changed when indicated on the
control panel or when the ice/water dispenser has
not been used for more than 30 days.
> With each filter replacement, sanitise the ice
and/or water distribution system using a food gra-
de disinfectant (with sodium hypochlorite), which
does not alter the characteristics of the materials.
Rinse with at least 2 litres of water before use.
> Only original spare parts supplied by the manu-
facturer should be used when replacing compo-
nents in the ice and water dispenser.
> Any work on the appliance must be carried out
by a qualified technician or the After-sales Service.
2.1 Installation
Make sure that installation is performed correctly,
adhering to all directions in the specific installation
manual provided with the appliance.
Attention
Do not use extension cords and/or
multiple adapters for the power supply
connection.

2.2 Connection to the water system

The models provided with Ice Maker require a con-
nection to the domestic water supply system. This
can be executed through the 1/4" water line (copper
or polyethylene)to the house water supply.
The system pressure must be between from 8 psi
to 75 psi (between 0.5 bar and 5 bar).
Different pressures can cause malfunctions or le-
aks in the water system.
The appliance should be supplied only with drinka-
ble water.
EN
5