Stand-Proud (For Standplus And X-Pro Series); Panels Mounting; Decorative Door And Bottom-Drawer Panels Layout - Fhiaba Integrated Serie Notice D'installation

4.5 Stand-Proud (for StandPlus and
X-Pro series)
Niche 610 mm (24")
KCLXB: Stand-proud (J-profile) Lateral connection
Kit (not included - must be ordered as a separate
accessory)
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
¾"
20 ( )
25 (1")

5. PANELS MOUNTING

INTEGRATED SERIES
5.1 Decorative door and Bottom-Drawer
panels layout
The dimensions of the panels are indicated in the
table and drawings on subsequent pages.
Nevertheless, according to the requirements for
aligning with other kitchen structures, the door
panel can be higher than the upper edge of the
refrigerator door, and the drawer panel can be
lower than the edge of the drawer.
The panels must be mounted using special bra-
ckets which attach to adjustable devices provided
on the door and drawer and with brackets that
anchor and adjust the panel's vertical direction.
Brackets and fixing screws are provided with the
¾"
20 ( )
appliance and must be applied to the panel as in-
25 (1")
dicated.
Operate as follows:
To prepare the panels to be mounted on the ap-
pliance, follow these steps, working on the back
of the panel.
Door Panel
> Draw a vertical center line on the panel from
top to bottom 1 ].
> Starting from the bottom edge of the panel,
mark the positioning of the brackets
2
EN
1
[ 2 ].
17