Fhiaba Integrated Serie Notice D'installation page 29

5. PANELS MOUNTING
> It is now possible to align panels to adjacent
cabinets in height using the lower alignment
[ 3 ]
bolts and brackets,
ning the screws into position as needed. With the
screw slighty tightened, move the panel sideways
manually to align it to the other panels on the unit
or other adjacent structures.
Set the bottom adjustment bolts using the lock
nut once you are happy with the height alignment.
3
>
Depth alignment: working from the inside of
the drawer, after lifting up the magnetic seal or
rotating the cover plate where necessary, adjust
the panel position in the Z-direction by adjusting
the shoulder bolts and setscrews with the 4mm
hex key in conjunction with each other finally
locking each mounting position in place
> Hook the panel to the fixing devices starting
from the top aligning brackets
6
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
tightening or untighte-
[ 4 & 5 ].
4
5
[ 6 ].
>
At this point, alignment between the panel and
adjacent cabinets can be adjusted using the ali-
gnment brackets and small brackets
>
Vertical alignment: tighten or loosen the screw
in the brackets to raise or lower the panel
9
> Depth alignment: working from the inside of
the door, after lifting up the magnetic seal on the
handle side and rotating the plastic covers on
the hinge side, adjust the panel position in the
Z-direction by adjusting the shoulder bolts and
setscrews with the 4mm hex key in conjunction
with each other finally locking each mounting po-
sition in place. [ 10 & 11
Once the front panel has been adjusted,
check that the gasket has been repositioned
correctly to assure the door/drawer are
closing correctly and avoid operational
errors of the unit.
[ 7] [ 8
and
7
8
[ 9 ].
].
10
11
29
EN
].