Completing The Installation; Anti-Tipping Safety Assembly; Mounting The Handles On Stainless Front - Fhiaba Integrated Serie Notice D'installation

7. COMPLETING THE INSTALLATION

7.1 Anti-tipping safety assembly

If the appliance(s) is/are not connected
through the side profile trims to secured
cabinetry you must install the anti-tip
brackets to ensure the product does not fall
forward during use and cause damage or
injury. Failing to secure the appliance(s) se-
curely will void any warranty claim attribut-
able to a tipping situation.
Operate as follows:
> The brackets should be applied as illustrated us-
ing the provided screws If using the anti-tip brack-
ets, lag into wood framing or concrete - drywall will
not hold the weight of appliance.
Place a bracket on the top of the appliance in corre-
spondence to the fixing holes and against the wall
[ 1 ].
" )
⁄
1 1
4 5 (
> Mark up the holes position on the wall
2
> Drill the wall with an 8 mm (3/8") bit and insert
the expansion plug [ 3 ].
3
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
> Reposition the bracket and fix it first to the cabi-
net and then to the wall
4
In order to use the anti-tip brackets on the
top compressor models, it will be neces-
sary to temporarily remove the top, metal
ceiling / shield to access the bolting points
for the brackets./ shield to access the bolt-
ing points for the brackets.
7.2 Mounting the handles
on stainless front
To mount the handles onto the door and
the drawer operate as follows:
Operate as follows:
> Insert the handle ends onto the supports alrea-
dy installed on the door and the drawer
1
2 x
6 x
[ 2 ].
> Screw in the Allen screws available on the handle
2
The screws must be tightened in by means of a
2.5 mm (1/8") hex key or bit.
[ 4 ].
[ 1 ].
[ 2
33
EN
].