Fhiaba Integrated Serie Notice D'installation page 31

> Access the back of the appliances to mount the
joining brackets: fix one side of the top and lower
brackets to one of the appliances and subsequently
[ 2 ].
to the other
2
> Next join them at the front attaching the two
profiles with the supplied screws or rivets
Attach the bracket on top of the units (if applicable)
[ 4 ].
as per figure
3
>
Finish off by mounting the central profile cover
onto the central profiles, by pushing it until a click
[ 5 ].
is heard
5
>
Once completed, push the units into their final po-
[ 6 ].
sition
If the units are to be installed inside a niche or
within an enclosed structure, it is necessary to
accommodate air flow at the back of the niche to
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
assure proper ventilation at the back of the unit of
about 5mm. Always mount front panels on door and
drawer before pushing the unit into its final position
inside the niche or structure.
>
feet and wheels to correct it.
>
screwing through the side profiles trims factory-
installed on the appliance
ets included with the appliance that are installed
by
and the drawer open.
6
[ 3 ]
.
4
>
insert them laterally and then push firmly until a
"click" is heard
Check the levelling of the appliance, adjusting its
Secure the appliance to the adjacent cabinets by
you. To make this operation easier keep the door
Mount the covering frames onto the profiles, first
[ 8 ].
7
Take care as appliances will be front-
heavy and may tip with doors and draw-
ers open before they are secured to the
adjacent furniture.
[ 7 ] or the plastic brack-
8
31
EN