Kroeplin C Série Mode D'emploi page 31

Program: MIN / MAX / HOLD
Important:
The measuring axis
must be in vertical
position to the
measuring
surface!
Important:
The measuring axis must
be in vertical position to
!
the measuring surface
Important:
The fixed flat contact
must be square against
the part to be measured!
Hold gage steady around
2s!
Determination of the minimum measuring value via pivoting
the gage (optimal measurement)
Measured value
too high
Determination of the maximum measuring value for measurement of
narrow grooves via lateral displacement of the gage, where the gage
cannot be pivoted vertically.
Measured value
too small
For checking round parts it is advisable to use measuring gages with
chisel contacts ( Technical Data).
Measurement of flat material (e.g. foam material) with flat measuring
contacts. Take note of the measuring force!
The movable flat contact aligns optimally so a pivoting or moving of the
gage is not necessary.
Fixed flat
contact
Measured value Measured value
correct
Measured value
correct
Movable flat
contact
too high
Measured value
too small
9