Table Des Matières - Hitachi CS40EM Mode D'emploi

MANUFACTURER : Nikko Tanaka Engineering Co.,LTD
DECLARES THAT THE DESIGN OF THE MACHINE DESCRIBED BELOW :
Model
Serial no.
Make
CONFORMS TO THE REQUIRMENTS OF THE MODIFIED MACHINES
DIRECTIVE (Directive 98/37/EC, EMC 89/336/EEC) AND TO THE NATIONAL
REGULATIONS GOVERNING ITS TRANSPOSITION ABROAD (ISO11681-1,
ISO12100-1 and -2, CISPR 12) : AND
THAT IT HAS BEEN ISSUED WITH A
BY 404, SMP Svensk MaskinprovningAB, Fyrisborgsgaian 3, SE-754 50, Uppsala,
Sweden.
Signed in Chiba, Japan
Yoshio Osada
Director
Contents
1. For Safe Operation ................................................................... 4
2. Explanation of Symbols on the Machine .................................. 6
3. Description ............................................................................... 7
4. Installing Guide Bar and Saw Chain ......................................... 8
5. Fuel and Chain Oil .................................................................... 9
6. Operating the Engine ............................................................. 10
7. Sawing .................................................................................... 12
8. Maintenance ........................................................................... 13
9. Maintenance of Saw Chain and Guide Bar ............................ 14
10. Troubleshooting Guide ........................................................... 15
11. Specifications ......................................................................... 16
DECLARATION OF CONFORMITY
(Directive 98/37/EC, EMC 89/336/EEC)
and to the regulations governing transposition
Internal control production
3-4-29 Tsudanuma
Narashino
Chiba, JAPAN
: CS40EM/45EM
: E57001 and up
: Nikko Tanaka Engineering
CE CERTIFICATE, NO. 404/05/1070
05/01/2007
G
B
GB-3