Hood Transition - Thermador PROFESSIONAL Série Manuel D'installation

Hood Transition

The supplied transition mounts to the top or rear of the
hood depending on the discharge direction.
10"
(254 mm)
Duct
1" (25.4 mm)
screw x 2
/ "
5 16
4
(110 mm)
21¾"
(553 mm)
11 "
1
/
16
(43 mm)
Figure 4: Transition Cutout Dimensions
Assembly of the Transition:
A minimum height clearance of 6" (152 mm) is needed
above the hood for transition mounting. See Figure 1 on
page 3 for overall hood dimensions.
1. Depending on direction of discharge, align mounting
2. Fasten transition to hood using (2) 1" (25.4 mm) sheet
3. Seal connection between transition and hood with
4. Remove tape holding damper closed.
Figure 3: Transition
4¼"
(108 mm)
holes at base of transition with the mounting holes of
the ½" (13 mm) flange located at the top or rear of the
hood.
metal screws included with hood.
aluminum tape.
1
3
Figure 5: Transition Connection
2
English 7