Beurer BM 47 Mode D'emploi page 30

Display accuracy Systolic ± 3 mmHg,
diastolic ± 3 mmHg,
pulse ± 5 % of the value shown
Measurement inac- Max. permissible standard deviation
curacy according to clinical testing:
systolic 8 mmHg /diastolic 8 mmHg
Memory 4 x 30 memory spaces
Dimensions L 134 mm x W 102 mm x H 52,5 mm
Weight Approximately 280g (without batter-
ies and cuff)
Cuff size 22 to 35 cm
Permissible operating +10 °C to +40 °C, ≤ 85 % relative air
conditions humidity (non-condensing)
Permissible storage -20 °C to +50 °C, ≤ 85 % relative air
conditions humidity, 800-1050 hPa ambient
pressure
Power supply 4 x 1,5 V
Battery life For approx. 500 measurements,
depending on the blood pressure
level and/or pump pressure
Classification Internal supply, IP20, no AP or
APG, continuous operation, type BF
applied part
AA batteries
30
The serial number is located on the device or in the battery
compartment.
Technical information is subject to change without notifica-
tion to allow for updates.
• This unit is in line with European Standard EN 60601-1-2
(In accordance with IEC 61000-4-2, IEC 61000-4-3 and
IEC 610004-8) and is subject to particular precautions
with regard to electromagnetic compatibility (EMC). Ple-
ase note that portable and mobile HF communication
systems may interfere with this unit.
• This device is in line with the EU Medical Devices Direc-
tive 93/42/EEC, the „Medizinproduktegesetz" (German
Medical Devices Act) and the standards EN 1060-1 (non-
invasive sphygmomanometers, Part 1: General require-
ments), EN 1060-3 (non-invasive sphygmomanometers,
Part 3: Supplementary requirements for electro-mechani-
cal blood pressure measuring systems) and IEC 80601-2-
30 (Medical electrical equipment – Part 2 – 30: Particular
requirements for the safety and essential performance of
automated non-invasive blood pressure monitors).
• The accuracy of this blood pressure monitor has been
carefully checked and developed with regard to a long
useful life. If using the device for commercial medical pur-
poses, it must be regularly tested for accuracy by appro-
priate means. Precise instructions for checking accuracy
may be requested from the service address.